Stihl HL 56 K User Manual

HL 56 K
English
18
Controls
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 = Stop
positions.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position, i.e. when it is not depressed:
The ignition is switched on – the engine
is ready to start. If the stop switch is
moved to the 0 position, the ignition is
switched off. The ignition is switched on
again automatically after the engine
stops.
Starting the Engine
N Press the manual fuel pump
bulb (4) at least five times – even if
the bulb is already filled with fuel.
Cold engine (cold start)
N Press in the choke lever (5) and turn
it to g at the same time.
Warm engine (warm start)
N Press in the choke lever (5) and turn
it to < at the same time.
Also use this setting if the engine has
been running but is still cold.
Cranking
N Place the unit on the ground: It must
rest securely on the engine support
and the gearbox housing.
N If fitted: Remove blade scabbard
from the cutting blades.
To reduce the risk of accidents, check
that the cutting blades are not touching
the ground of any other obstacles.
N Make sure you have a firm footing,
either standing, stooping or
kneeling.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger,
lockout lever or stop switch.
NOTICE
Do not stand or kneel on the drive tube.
Starting / Stopping the
Engine
2
1
3
545BA002 KN
4
547BA015 KN
5
547BA016 KN
5
547BA017 KN
547BA018 KN

Stihl HL 56 K Specifications

General

Brand	Stihl
Model	HL 56 K
Category	Trimmer
Language	English