HS 82 R, HS 82 RC, HS 82 T
English
12
The rear handle can be turned through
90° to the left or right for better control
and comfort in all cutting situations.
N Let go of the throttle trigger. Do not
open the throttle.
N Release the lock (1).
N Turn the handle (2) to the required
position and re-engage the lock (1).
The throttle trigger may be used again
when the handle is locked in position.
Do not operate the throttle while the
handle lock is released. Never release
the lock while you are operating the
throttle.
Versions with Easy2Start
WARNING
This machine is extremely simple and
easy to start, even for children.
To reduce the risk of serious or fatal
injury:
– do not allow children or other
unauthorized persons to attempt to
start or otherwise use the machine
– never allow children or
unauthorized persons access to the
machine
– never leave the machine
unattended while working or during
work breaks
– after work, store in a safe, secure
location out of the reach of children
and other unauthorized persons
N Observe safety precautions – see
chapter on "Safety Precautions and
Working Techniques".
The stop switch (1) is in the normal run
position I.
N Depress the trigger lockout (2) and
pull the throttle trigger (3) – hold
them in that position.
N Press in the starting throttle lock (4).
N Let go of the lockout lever, throttle
trigger and starting throttle lock.
This is the starting throttle position.
N Set the choke lever (5) to
N Press the manual fuel pump bulb at
least five times – even if the bulb is
filled with fuel.
Rear Handle
Starting / Stopping the
Engine
g if the engine is cold
e for warm start – also use this posi
-
tion if the engine has been running
but is still cold.