Stihl HS 82 RC User Manual

HS 82 R, HS 82 RC, HS 82 T
English
17
N Use a 15 mm socket wrench to
unscrew the spark arresting
screen (3).
N Clean the spark arresting screen. If
the screen is damaged or heavily
carbonized, fit a new one.
N Refit the spark arresting screen.
N Fit the exhaust pipe.
N Fit the screws.
N If the engine is down on power,
difficult to start or runs poorly at idle
speed, first check the spark plug.
N Fit a new spark plug after about 100
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the Spark Plug
N Pull off the spark plug boot.
N Unscrew the spark plug.
Checking the spark plug
N Clean dirty spark plug.
N Check electrode gap (A) and
readjust if necessary – see
"Specifications".
N Rectify the problems which have
caused fouling of the spark plug.
Possible causes are:
– Too much oil in fuel mix.
– Dirty air filter.
– Unfavorable running conditions.
WARNING
If the spark plug comes with a
detachable adapter nut (1), screw the
adapter onto the thread and tighten it
down firmly to reduce the risk of arcing
and fire.
Spark Plug
0023BA024 KN
000BA039 KN
A
1
000BA045 KN

Stihl HS 82 RC Specifications

General

Brand	Stihl
Model	HS 82 RC
Category	Trimmer
Language	English