62 Series 4180 Powerhead
– Remove the engine, b 7.6.1
: Take screw (1) out of fan housing.
– Remove the fan housing.
Different fan housings are fitted to
the powerhead:
Pressure die cast fan housing.
Polymer fan housing.
Differences in removal and
installation procedures for the clutch
drum and bearing are described
below.
Polymer fan housing.
: Support the ball bearing at the
clutch drum (2) side with removal
tool (1) 5910 890 4602.
– Turn the removal tool and fan
housing over – so that the fan
housing rests on the removal
tool.
All models
: Remove the sleeves (1) together
with rubber mounting.
: Insert installing tool (2)
4180 893 4400 in square hole in
clutch drum.
: Apply puller (1) 5910 890 4400
with No. 2 jaws and clamp the
arms.
: Jaws must engage the cutouts in
the clamp (1).
: Pull clamp (1) with rubber
element (2) out of fan housing.
– Coat rubber element and rubber
mounting of sleeves with press
fluid, b 12
– Push rubber element into clamp
first, then press it into the fan
housing.
The rubber element with clamp is
recessed about 2 mm in the fan
housing. It is therefore necessary to
use press sleeve 4119 893 2400 for
this operation.
Reassemble all other parts in the
reverse sequence.
10. AV System
To Next Page
Loading...
Need help?
General
