40
english
HT 70, HT 75
: File the top of the depth gauge
parallel to the stamped service
marking (see arrow) – but do not
lower the highest point of the depth
gauge in this process.
The kickback tendency of the
chainsaw is increased if the depth
gauges are too low.
: Place filing gauge on the chain –
highest point of depth gauge must
be level with the filing gauge.
After sharpening
After sharpening, clean the chain
thoroughly, remove filings or grinding
dust – lubricate the chain thoroughly.
Before long out-of-service period
Clean the chain with a brush and store it
in a well-oiled condition.
Information for re-ordering chain
Sharpening Toools
(special accessories)
689BA044 KN
689BA052 KN
Type: Picco Micro Mini
Pitch: 3/8" P (9.32 mm)
Number of tie
straps: 44
Cutting length: 12" (30 cm)
Description Part No.
Round file
5/32" (4.0 mm)
diameter 5605 772 4006
File holder 5605 750 4327
Filing gauge 0000 893 4000
Flat file 0814 252 3356
Sharpening kit
(includes all parts
listed above) 5605 007 1026
To Next Page
Loading...
Need help?
General
