20
english
HT 70, HT 75
For automatic and reliable
lubrication of the chain and guide
bar: Use only a quality,
environmentally compatible
chain and bar lubricant. STIHL
chain lubricant with non-fling
additive or the rapidly
biodegradable STIHL BioPlus is
recommended.
Biological chain oil must be resistant
to aging (e.g. STIHL BioPlus) since
it will otherwise quickly turn to resin.
This results in hard deposits that are
difficult to remove, especially in the
area of the chain drive and chain. It
may even cause the oil pump to
seize.
The service life of the chain and guide
bar depends on the quality of the
lubricant. It is therefore essential to use
only a specially formulated chain
lubricant!
If special chain lubricant is not available,
you may – in an emergency – use an HD
single grade or multigrade engine oil
with a viscosity that suits the prevailing
outside temperature.
Do not use waste oil! Waste oil
does not have the required
lubricating properties and is
unsuitable for chain lubrication.
Medical studies have shown that
renewed contact with waste oil can
cause skin cancer. It also harms the
environment!
A full chain oil tank is sufficient for
about one tankful of fuel. Check the
oil level regularly during cutting
work. Never allow the oil tank to run
dry!
: Thoroughly clean the filler cap and
area around it so that no dirt can fall
into the tank.
: Position the unit so that the filler cap
faces up.
If the oil level in the tank does not
change, this may be due to a problem in
the oil supply: Check chain lubrication,
clean the oilways, contact your STlHL
dealer for assistance if necessary.
Chain Oil Filling Chain Oil
Tank
390BA047 KN
To Next Page
Loading...
Need help?
General
