subzero.com
|
7
Refrigerator Storage
GLASS SHELVES
To remove or adjust a glass shelf, tilt up, then lift up and out.
To reposition, insert shelf in the tracks along the back wall,
then lower the front until it locks into position. Refer to the
illustration below.
The stationary glass shelf at the bottom of the compartment
should be placed with beveled edge facing front. Rear sup-
port legs space the shelf away from the back wall to ensure
proper air ow through the unit.
IMPORTANT NOTE: Use care when handling glass shelves to
prevent breakage or scratching the interior.
CAUTION
Glass shelves should warm to room temperature before
immersing in warm water.
REFRIGERATOR DRAWERS
To remove a refrigerator drawer, pull open until the drawer
stops. Lift the front of the drawer slightly and pull straight
out. To reinstall, pull drawer carrier out and align the bottom
of the drawer with the carrier. Refer to the illustration below.
Dividers in refrigerator drawers can be removed by pulling
straight up. To replace, align tabs on the divider with
notches in the drawer and push down.
STORAGE
Refrigerator drawer removal.
Glass shelf removal.
To Next Page
Loading...
Need help?
General
