20
6. Within eight (8) seconds after performing
Step 5, start the following operation.
(1)Turn the main switch to the “ON & OFF”
position and hold it for five (5) seconds or
longer, then release it to the “PUSH START/
STOP” position.
Repeat this operation for two more times.
(2)The LED on the key-fob blinks once and the
buzzer sounds once.
After that, the LED on the key-fob blinks to
indicate the passcode by the number of
blinks, as shown in the illustration.
This is indicated repeatedly.
NOTE:
The passcode indication will not start if Step (1)
is not performed within eight (8) seconds or the
operation fails.
In this case, turn the main switch to the “ON &
OFF” position and then release it to the “PUSH
START/STOP” position to turn the Keyless Start
System OFF. After that, retry the procedure
from Step 5.
7. After the passcode confirmation is com-
pleted, turn the main switch to the “ON &
OFF” position and then release it. The main
switch automatically returns to the “PUSH
START/STOP” position. The Keyless Start
System turns OFF and the passcode indica-
tion stops.
ON & OFF ON & OFF
Hold it for five (5) seconds.
PUSH
START
STOP
PUSH
START
STOP
Example: In the case of passcode 1234
LED
PROPELLER SELECTION
AND INSTALLATION
PROPELLER SELECTION
It is essential to use a propeller on your out-
board motor that is properly matched to your
boat’s operating characteristics. The speed of
the engine when you operate your boat at full
throttle depends on the propeller you use.
Excessive engine speed can seriously damage
the motor, while low engine speed at full throttle
will adversely affect performance. Your operat-
ing load will also affect propeller selection.
Smaller loads generally require larger-pitch pro-
pellers; larger loads generally require smaller-
pitch propellers. Your authorized Suzuki Marine
Dealer will assist you in selecting a suitable pro-
peller for your boat.
You can determine if your propeller is appropri-
ate for use with your boat by using a tachome-
ter to measure engine speed when operating
your boat at full throttle, under minimum load
conditions. If you are using an appropriate pro-
peller, the engine speed will be within the fol-
lowing range:
If the engine speed is not within this range, con-
sult your authorized Suzuki Marine Dealer to
determine which propeller size is best for you.
NOTICE
Installing a propeller with either too much or
too little pitch will cause incorrect maximum
engine speed, which may result in severe
damage to the motor.
Ask your authorized Suzuki marine dealer to
assist you in selecting a suitable propeller for
your boat.
Full throttle
operating
range
DF70A
5000 – 6000
r/min. (min
–1
)
DF80A
5000 – 6000
r/min. (min
–1
)
DF90A
5300 – 6300
r/min. (min
–1
)
DF100B
5700 – 6300
r/min. (min
–1
)
To Next Page
Loading...
Need help?
General
