27
NOTICE
If the diagnostic system activates while you
are operating your outboard motor, there is an
abnormal condition in one of the sensor sig-
nals of the control system.
Consult your authorized Suzuki marine dealer
for repair of the control system.
OIL CHANGE REMINDER
SYSTEM
This system informs the operator of the time for
replacing engine oil on the basis of the mainte-
nance schedule.
The system is designed to register the total
operating hours of the outboard motor and
function its operation when the preprogrammed
hours have reached.
(Refer to the INSPECTION AND MAINTE-
NANCE section and the last page.)
SYSTEM ACTIVATION
TILLER HANDLE MODEL
When the total operating hours have reached
the preprogrammed hours, the red OIL lamp will
flash while the engine is running. This indication
will repeat until you cancel the system activa-
tion.
REMOTE CONTROL MODEL
When the total operating hours have reached
the preprogrammed hours, the red OIL lamp will
flash and a buzzer will sound. This OIL lamp
indication will repeat until you cancel the sys-
tem activation.
The buzzer sound will be stopped after approx.
thirty seconds.
NOTE:
Ignition key is turned to the “ON” position while
engine is not running.
This system activates, the red OIL lamp will
flash but no buzzer sound. This OIL lamp indi-
cation will repeat until you cancel the system
activation.
CANCELLATION
TILLER HANDLE MODEL
1. Start the motor.
Make sure that the motor is in “NEUTRAL”
and the throttle grip is fully closed.
NOTE:
The engine stops when the engine stop button
is kept to push more than 0.5 seconds.
2. Push the engine stop button 1 three times
within 4 seconds so that the engine should
not stall.
The red OIL lamp is no longer lit when the
reminder cancellation is successful.
To Next Page
Loading...
Need help?
General
