51
OPERATION OF MOTOR
COVER LEVER
MOTOR COVER REMOVAL
Remove the motor cover by unlocking the lever
1, 2 and 3. Pull out and turn up the levers to
unlock. Turn down and push in the levers to
lock.
INSPECTION BEFORE
BOATING
It is important to make sure that your boat and
motor are in good condition and that you are
properly prepared for an emergency.
Always perform the following checks before you
begin boating:
• Make sure that you have enough fuel for
the intended run.
• Check the level of engine oil in the sump.
To check the oil level:
NOTE:
To avoid an incorrect assessment of engine oil
level, check the level only when the engine has
cooled.
1. Place the motor in a vertical position, then
remove the motor cover. Refer to the OPER-
ATION OF MOTOR COVER LEVER section.
2. Turn the oil dipstick 90 degrees to the left
and pull it out, and wipe oil off with a clean
cloth.
8
WARNING
Failure to inspect your boat and motor before
beginning a trip can be hazardous.
Before boating, always perform the inspec-
tions described in this section.
NOTICE
Running the engine with an insufficient
amount of oil can cause serious engine dam-
age.
Always check the oil level before each trip and
add oil if necessary.
To Next Page
Loading...
Need help?
General
