35
If not equipped with Keyless Start System:
NOTICE
Damage can occur if you use the tilt bracket
other than when the boat is moored or is oth-
erwise stationary.
The tilt bracket relieves pressure from the
power trim and tilt and should only be used
when the boat is stationary. Do not use the tilt
bracket when trailering your boat and motor.
Refer to the TRAILERING section of this man-
ual.
CAUTION
The remote Power Trim and Tilt switch will
work when the ignition switch is off. If some-
one activates the switch while you are moving
the tilt bracket, your hand could be injured.
Keep all persons away from the remote Power
Trim and Tilt switch while you are moving the
tilt bracket.
NOTICE
Damage can occur if you use the tilt bracket
other than when the boat is moored or is oth-
erwise stationary.
The tilt bracket relieves pressure from the
power trim and tilt and should only be used
when the boat is stationary. Do not use the tilt
bracket when trailering your boat and motor.
Refer to the TRAILERING section of this man-
ual.
INSPECTION BEFORE
BOATING
It is important to make sure that your boat and
motor are in good condition and that you are
properly prepared for an emergency.
Always perform the following checks before you
begin boating:
• Make sure that you have enough fuel for
the intended run.
• Check the level of engine oil in the sump.
To check the oil level:
NOTE:
To avoid an incorrect assessment of engine oil
level, check the level only when the engine has
cooled.
1. Place the motor in a vertical position, then
remove the motor cover by unlocking the
lever 1 and 2.
WARNING
Failure to inspect your boat and motor before
beginning a trip can be hazardous.
Before boating, always perform the inspec-
tions described in this section.
NOTICE
Running the engine with an insufficient
amount of oil can cause serious engine dam-
age.
Always check the oil level before each trip and
add oil if necessary.
To Next Page
Loading...
Need help?
General
