(1)
"LOCK" button
(2)
"UNLOCK" button
There are two ways to lock or unlock
all
doors simultaneously
by
operating the
remote
controller near the vehicle.
Central
door
locking
system
•
To
lock all doors, push the "LOCK" but-
ton
(1)
once.
•
To
unlock only the driver's door, push the
"UNLOCK" button
(2)
once.
•
To
unlock other doors, push the
"UNLOCK" button
(2)
once again.
Central
door
locking
system
with
the
dead
lock
system
(if equipped)
If
you
want to prevent tamper-unlocking
of
the door locks, use this method. When the
dead lock system
is
activated, operating
the lock knobs will not unlock the side
doors.
To
activate this system:
To
lock all doors, push the "LOCK" button
(1)
twice within 3 seconds.
To
release this system:
•
To
unlock only the driver's door, push the
"UNLOCK" button
(2)
once.
•
To
unlock other doors, push the
"UNLOCK" button
(2)
once again.
A.
WARNING
Do
not
activate the dead
lock
system
if
there
are
occupants
in
the
vehicle.
They
will
be
locked
in
the vehicle
and
cannot
unlock
the
doors
from
inside.
The turn signal lights will flash once when
the doors are locked
and
then
the
turn sig-
nal lights will flash once again when the
doors are locked with the dead lock sys-
tem.
When the doors are unlocked:
• The turn signal lights will flash twice.
•
If
the interior light switch
is
in
the middle
position, the interior light will turn
on
for
about
15
seconds and then
fade
out.
If
you
push
in
the ignition switch or insert
the key during this time,
the
light will
start to
fade
out immediately.
BEFORE DRIVING
Be
sure the doors are locked after
you
operate the "LOCK" button.
If
no door is
opened within about
30
seconds after the
"UNLOCK" button
is
operated, the doors
will automatically lock again.
NOTE:
•
The maximum operating distance
of
the
remote controller is
about
5 m (16 ft.),
but this can vary depending on the
sur-
roundings, especially
near
other trans-
mitting devices such as radio towers
or
CB (Citizen's Band) radios. .
•
The door locks can
not
be
operated with
the remote controller if the ignition switch
is in
a position other than "LOCK",
or
the
ignition key is inserted
in
the ignition
switch,
or
if
any
door is open.
• If you lose one
of
the remote controllers,
ask
your SUZUKI dealer as soon as pos-
sible for a replacement. Be sure to have
your
dealer program the new remote
controller code
in
your vehicle's memory
so that the
old
code is erased.
1-6
To Next Page
Loading...
Need help?
General
