Index
1. Check Tools
2. Check the circumstances before installing
3. Check and adjust levelness.
4. Assembly
(1) Install Y fixed Frame
(2) Install the table
(3) Assemble Spool Stand and OP Box
(4) Assemble the Frame
(5) Assemble the bar switch and connetc cable
(6) Assemble the Offset Switch clear the cable
5. Running the machine without needle
6. Check the levelness and assemble the Table Support
7. Check the needle position and correct it
8. Re-set the upper dead & needle point of needle bar
9. Check and correct the Rotary Hook
10.Test the machine operation and Running
11.Test the Sewing
SB Multi Heads Series Installation Manual
Page 1 Of 17 (주)SUNSTAR SWF CS Center
To Next Page
Need help?
General
