1
Check Tools
(1) Height Guage (1 needed include indigator)
(2) Set the Needle bar JIG (17.7MM)
(3) Precision Level(2/100mm, 1 Q'ty), Water Hose.
(4) Presser Foot Level Guage (1T)
(5) B.D.P JIG and B.D.P Guage.(+,- Guage)
(+ Guage: 0.1 / 0.2T , - Guage: 4.3 / 4.0T )
(6) Tester
(7) Embroidery A/S Tool Box 1SET
2
Check the circumstances before installing
(1) Safe arrival of the machine
Weight of SB Series machine is 3.0t (Not include Option) .
※ When moving the machine , must use the a forklift truck at least 5Ton above
(2) Check the voltage specifications
When install the machines, Main power capacity of power consumption is 3KW(official) but recommend
5KW. If the capacity of electricity is not enough, the right operation of machines will not be possible.
So, you must check in advance.
※ Under 3 Phase/ 5KW of power equipment , additonal power build up will be needed
(3) Check the input voltage and connect the power of machine.
After checking the Main Switch of machine is turned off Check the status of R,S,T .
(If the input voltage is different from machine voltage, adjust it by control box)
Open the Contl box and then check the voltage specifications of embroidery (refer to pic 2)
Pic 1 Pic 2
Check the all status of voltage
(R,S),(S,T),(R,T).If operating voltage of
the input voltage is +10% to -10% is fine.
If you want to change the
machine voltage specifications
insert it to voltage
specification which you want to
change the connector
S
T
R
Page 2 Of 17 (주)SUNSTAR SWF CS Center
To Next Page
Loading...
Need help?
General
