EasyManuals Logo
Home>Swift>Motorhomes>Escape 664

Swift Escape 664 User Manual

Swift Escape 664
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
Water Heating
Make sure the water tank is not empty.
Water is heated by gas and /or an 850W (3.7amp) electrical heater.
Electricity is usually provided as part of the campsite fee at no extra cost.
The boiler can heat 10 litres of water in around 20 minutes, or around 80 minutes if
room heater is being used as well.
For showering, heat the water to 70 degrees as this will mean that you add more cold
water and therefore the hot water will last longer.
Electric Heating:
Electric water heating is controlled only by the switch under
the right hand bench seat. It is thermostatically controlled and
can be left on.
Gas Heating
Make sure the gas is turned on outside the vehicle.
On the left side of the vehicle, remove the cover over the
boiler flue before operation, and place it on the dashboard as
a reminder to the driver to replace it before driving further.
If the cover is stiff to remove, push down on the top with one
hand, and with your lower hand prise the cover outwards, allowing your knuckles to
lever against the side of the van.
If the gas water heater flame goes out, a red LED appears within the black dial of the
Ultrastore heater control. Turn off and leave for five minutes to cool down. Ensure that
the gas is connected and the exhaust cover is removed, then try and switch on again.
Water heater controls
ON/OFF
Water tempe
rature settings
30 to 70 degrees

Other manuals for Swift Escape 664

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Swift Escape 664 and is the answer not in the manual?

Swift Escape 664 Specifications

General IconGeneral
BrandSwift
ModelEscape 664
CategoryMotorhomes
LanguageEnglish

Related product manuals