10. FUEL SYSTEM
10-2
Maintenance Information
Precautions in Operations
Warning
Gasoline is a highly flammable material and may explosive under circumstance. Thus, always work
in a well-ventilated place and strictly prohibit flame when working with gasoline.
y Care must be taken when dealing with gasoline, and always work in a well-ventilated place and
strictly prohibit flame.
y When disassembling fuel system parts, pay attention to O-ring position, replace with new one as
re-assembly
y It has to conduct air bleeding operation as removed the oil tube.
y Idle speed adjustment.
Specification
Item DD 50
Venturi diameter 14 mm
Fuel level
8.6±1.0mm
Air screw opener 1 3/8
Idle speed
2000±100 rpm
Throttle handle free play 2~6 mm
I.D. number PB2BE
Main jet #82
Fuel pump output 20 c.c. minimum.
Troubleshooting
Engine can not be started
1. No fuel in fuel tank
2. Fuel can not reach to carburetor
3. Too much fuel in cylinder
4. Clogged air cleaner
Stall after started
1. Incorrect idle speed adjustment
2. No spark on the spark plug
3. Low compression pressure
4. Rich mixture
5. Lean mixture
6. Clogged air cleaner
7. Inlet pipe leaking
8. Polluted fuel
Lean Mixture
1. Clogged carburetor jet
2. Clogged hose from carburetor to canister
3. Bend, squeezed or clogged fuel lines
4. Clogged fuel filter
5. Malfunction of float valve
6. Low fuel level in float chamber
7. Clogged vent pipe
8. Malfunction of fuel pump
Rich Mixture
1. Malfunction of float valve
2. Low fuel level in float chamber
3. Clogged carburetor air injector
This chapter Contents
To Next Page
Loading...
Need help?
General
