8
y Light Switches
When the switch is turned to this position as the engine is being started, headlight, rear light,
instrument panel light, and position light will come on. This is the high beam of headlight
switching switch.
When the switch is turned to this position as the engine is being started, rear light, instrument
panel light, and position light will come on.
y When the switch is turned to this position, all lights will go off.
y Electrical starter button
this is a starting motor button(switch) for engine starting.
With the main switch “on”, press this button while holding the front or rear brake lever will
start the engine.
y High/low beam switch
This is the high and low beam of headlight switching switch. Press this switch to switch between
high and beams.
This is for high beam.
This is for low beam.(please turn to low beam riding in city.)
y Passing switch
Turn ignition switch to the“ON” position and press this button down. Then, the high beam
of headlight will come on immediately to warn the driver of the vehicle ahead that you
intend to overtake him/her.(For overtaking, high beam indicator will come on at this time).
This button will return to original position after releasing.
CAUTION:
y Release this button immediately after engine has been starter, and never press the button
again to avoid damaging the engine.
y This mechanism is a safety design. The engine can only be started after the front or rear brake
lever (pedal) has been applied.
y Do not use light system. Turn headlight and turn signal light to the “off” position when the
engine is being started.
Passing
To Next Page
Loading...
Need help?
General