12
Handlebar Switches
Daytime Running Lights System
Turn the main switch to “ON” position, the position light, tail light, and license light will be on at
the same time.
After the engine is started, the headlight will be on. Until the main switch is turned to “OFF”
position, all lights will be off.
This is to increase the visibility at daytime and to secure road safety.
Ⓐ Passing Light Button / Dimmer Switch
When pushing the passing light button , the high beam indicator light goes on to signal the
driver of the vehicle ahead that you are about to pass.
Release to recover its original position.
High and low beam can be selected with this switch. When the headlight is on high beam , the
high beam indicator light goes on.
High beam
Low beam
Ⓑ Engine Stop Switch
This switch should normally remain in the position for the scooter to operate. In an
emergency, switch to the position to stop the engine.
Ⓒ Turn Signal Switch
When the turn signal switch is turned to the left or right , the corresponding turn signals
blink on and off. To stop blinking, push the switch in.
Ⓓ Horn Button
When the horn button is pushed when the ignition switch is turned on; the horn sounds.
When the main switch is turned to “ON”
position, Daytime Running Lights System is activated. If
the engine is not started for a long time to recharge the battery, the battery will be dried out of
Ⓖ
Ⓐ
Passing Light Button/ Dimmer Switch
Ⓑ Engine Stop Switch
Ⓒ Turn Signal Switch
Ⓓ Horn Button
Ⓔ
Ⓕ Idling Start & Stop Switch
Ⓖ Starter Button
To Next Page
Loading...
Need help?
General
