To Next Page

To Previous Page

Basic operation 31

Using the radio in different repeater areas

Your radio may have a group of channels programmed as a

voting group. The channels in the voting group all carry the

same traffic, but from different repeaters. As your radio

moves in and out of different repeater coverage areas, the

best communication channel is automatically selected for

youtouse, until a better communications channel is selected.

While voting is active, the amber LED glows and the

display shows:

■ the transmit channel,

■ the voting group number, or

■ or .

Activating voting

Voting can be activated by selecting a voting group (see

“Selecting a channel or group” on page 22) or by using a

function key programmed for voting.

Suspending a channel from a voting group

You may be able to use the function key programmed for

nuisance delete to temporarily delete one of the channels

from the voting group.

When that voting group is next selected, or after the radio has

been turned off and then on, the deleted channel is again

part of the voting group.

Alternatively, the function key programmed for voting may be

programmed so that a short key press turns on voting, and a

long key press activates nuisance delete.

■ Press and hold the function key programmed for voting to

remove the current channel from the voting group.

Tait TM8115 Operator's Manual

Other manuals for Tait TM8115