Taski ergodisc 238 Instructions Of Use

20
Machine installation
Attaching tools
Check:
• that the brush has not fallen below the red mark or a brush length of 1 cm.
• the pad for wear and foreign bodies (e.g. grains of sans) before use.
• that the tool is mounted.
Could cause damage to floor surface by negligence!
Recommended chemicals
Only use the chemical products recommended by the manufacturer.
The correct dosage is recommended on the product's packaging and on the "
TASKI Product Information Sheet".
Application technique
• 1 = Electr. spray device is not possible
• 2 = Machine performance is limited; for this reason not recommended
• 3 = Only when the additional weight from the front is taken away
• 4 = Machine weight only conditionally sufficient
• 5 = This application is only recommended when the power selection switch
is set to level 2 (high number of revolutions)
Beginning work
• Lay the tool on the floor in front of the machine.
• Stand behind the machine.
• Pull the height adjustment lever on the machine
handle and slowly lower the guide pillar into a
comfortable working position, making sure your
arms are almost straight.
• Let go of the height adjustment lever, the guide
pillar will locate into place and stay at that angle.
• Tilt the machine back slightly and position it
over the tool until it touches the back of the tool
unit.
• Return the machine to its upright position.
• Move the machine from left to right until the tool
locates into place.
Now the machine is ready for use.
Caution:
Using other chemicals (e.g. chemicals containing solvents,
chlorine, hydrochloric acid and hydrofluoric acid) can damage or
destroy the machine.
Machine 165 200 238
type 43DLS/
43DLSL
43LS/
43LSL
38LSL
Wet cleaning & prime cleaning yes yes yes
Spray cleaning yes yes 1
Shampoo wet yes yes 2
Shampoo dry yes yes 2
Polish yes yes yes
Burnish 4 4 no
Crystallize 4 4 no
Machine 400 438 duo
type 43HS/
43HSL
38HSL 43LHS/
43LHSL
Wet cleaning & prime cleaning no no yes
Spray cleaning yes yes yes
Shampoo wet no no 3
Shampoo dry no no 3
Polish yes yes 5
Burnish no no yes
Crystallize no no yes
Caution:
It is recommended that inexperienced users should first practice
operating the machine on a smooth surface with free areas until
they have mastered the handling of the machine.
• Connect the power supply cord to the mains
socket.
The display lights up.
• Lead the power supply cord with your hand.
Make sure that the power supply cord does not touch the tool.
• Hold on to the machine.
• Push the safety switch and press the operating
levers at the same time.
By doing this the tool is activated.
By slightly lifting the guide pillar the machine moves to the right
and by lowering it the machine moves to the left.

Taski ergodisc 238 Specifications

General

Brand	Taski
Model	ergodisc 238
Category	Floor Machine
Language	English