EasyManuals Logo
Home>Taurus>Vacuum Cleaner>Ultimate Lithium

Taurus Ultimate Lithium User Manual

Taurus Ultimate Lithium
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
CHARGING THE BATTERY
- Caution: A new battery is not fully charged and
must therefore be charged before the appliance
is used for the rst time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Plug the charger (P) into the mains.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 3 to 4 hours are needed for a
complete charge of the battery. Never attempt to
over-charge the battery (although it is recom-
mended that the rst charge of the battery be of
5 hours in duration).
- Connect the charger to the jack using the socket
on the appliance. The socket is located at the
back part of the appliance.
- The pilot light will come on to indicate that the
charger is charging the battery.
- At the end of the time period specied above,
remove the battery from the charger.
- When the battery is charged disconnect the
charger from the mains supply.
- NB: Do not use the appliance while it is connec-
ted to the charger.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that product’s packaging has been
removed.
- Before using this product for the rst time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use:
VACUUMING FUNCTION:
- Connect the tube in the air intake and the brush
at the end of the extencion tube. (H)
- To disconnect the extension tube of the vacuum
cleaner, press the release button of accessories
(H) and pull out. (Fig.3)
USE:
- Turn the appliance on, by using the on/off
button. (J)
- Turn the appliance on, by using one of the spe-
ed selection buttons.
FITTING AN ACCESSORY TO THE HAND
VACUUM:
- The folloring accessory is designed to inster
into handy vacuum cleaner and extention tube.
(Fig. 4)
- Accessory 3 in 1:
A-1 Upholstery brush.
A-2 Brush for furniture or textile.
A-3 Lance.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Remove the battery from the appliance if you
are not intending to use the appliance during an
extended period.
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
- Disconnect the hose from the vacuum cleaners
air intake. (Fig.5).
- Open the lid of the dust box and empty the
contents into the appropriate waste disposal
receptacle. (Fig.6).
- To clean the cyclone, disconnect the dust tank
pressing the butoon, turb the dust tank to the
left and pull out. (Fig.7)
CHANGING THE FILTERS:
- Dust tank HEPA lter (high efciency air lter
that efciently retains spores, ash, sawdust,
pollen…), it is advisable to change it a least
once a year or after every 50 hours of use, or if
its potency diminishes remarkably.
TO REMOVE THE FILTERS:
- Open the cover that contains the lter. (Fig.8).
- Remove the lter from its housing (Fig.9).
- To reassemble the lter, proceed with the above
instructions, in reverse order.

Other manuals for Taurus Ultimate Lithium

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taurus Ultimate Lithium and is the answer not in the manual?

Taurus Ultimate Lithium Specifications

General IconGeneral
BrandTaurus
ModelUltimate Lithium
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals