7
10. The ground wire hole does not exist. In a clear area about 3 inches (max) from the front edge,
drill a 3/16’’ pilot hole for the grounding screw through the left-hand side of the sleeve as
shown below. Pull the loose end of the ground wire out of the front of the sleeve and bend it
away from the opening. This will be attached to the air conditioner once installed.
11. Install the new unit into the wall sleeve.
12. To attach the ground wire to the new unit, remove the screw from the left side on the front.
13. Assemble and install the trim frame.
Existing Frigidaire sleeves may have older single sided intake grills, as pictured below.
To Next Page
Loading...
Need help?
General
