9
Seal Installation
1. Use 1’’x3/8’’x25’’ long seal in the center at the top of the sleeve. Remove the back paper and
press into position.
2. Use 1’’x3/8’’x14’’ seal both to the left and right sides of the sleeve.
3. Cut the 1’’x3/8’’x25’’ long seals to 14’’ length each and attach to the vertical sections of the
grill as shown.
4. Take the 1/2’’x3 1/2’’x1 1/2’’ centering blocks (one on each side wall). Place in the center of side
wall with the tapered end facing the opening.
Ground Wire Installation
1. Install screw end of the ground wire into the inside of the sleeve according to
preparation instruction.
2. Before sliding the unit all the way back, remove the second screw from left side of unit.
3. Remove plastic washer from screw.
4. Screw the other end of the ground wire into the unit as shown. Make sure the toothed washer
is against the cabinet
To Next Page
Loading...
Need help?
General
