TCL HH500V Quick Start Guide

EN - 10 EN - 11
• Connect your xed-line phone
To connect to a telephone, follow the steps below:
1. Insert a valid SIM card into device and power on device.
2. Connect the telephone with device ‘TEL’ port via telephone line.
RESET
TEL
FAQs
• How to change WiFi Password
1. Type hp://192.168.1.1 into the address bar and press the Enter key. The home
page will then load.
2. Click Log in and enter the password.
The password can be found on the label at the boom of your 5G CPE.
3. Go to Sengs > WiFi > Basic to change WiFi password.
• How to turn on or turn o the device
Press and hold the Power key for 1 second to turn on your 5G CPE.
Press and hold the Power key for 3 seconds to turn o your 5G CPE.
• How to restore factory sengs
When the device is turned on, use a paperclip or blunt pin to gently press and hold
the Reset key for 3 seconds unl the power indicator starts to ash, and nally turns
on.
• How to enable WPS funcon
To enable WPS, press and hold the WPS key for 3 seconds. The WiFi indicator will
start to ash blue. Then press the WPS key on the device you wish to connect to
within 2 minutes. Your 5G CPE will automacally assign your network sengs to the
device you wish to connect to.
Note:
Service available depending on your oer. Please check the condions of the oer
you have subscribed with your operator.

TCL HH500V Specifications

General

Brand	TCL
Model	HH500V
Category	Wireless Router
Language	English