Factory Alignment Specification of normal SIACP
Page 9 of 12
Item Sub-item Value/Sub-item Note
Burning
Mode
Off/On
Select panel On with left/right
key, Press “EXIT” key to enter
the burning mode;
Press “Menu” key on keyboard
to exit the burning mode
3)
ADC
Need not to do ADC when alignment
4)
W
hite Balance
Item Sub-item Value Note
Source HDMI,etc
For balance source˖
HDMI,VGA,DTV,PAL,SECAM,NTSC,Scar
t RGB,CPM, HDMI
Color Temperature Normal
/Warm/Cool
The value of Warm and cool is the offset
of Normal mode. Cool is the preset status
R Gain
R White balance
G Gain
G White balance
B Gain
B White balance
R Offset
R Gray balance
G Offset
G Gray balance
B Offset
B Gray balance
White Balance Init
Press “Right” key to initial the preset RGB
Gain/Offset value
Pic. Enhance On/Off
Press “Right” key to switch off all of the
items in the feature submenu. This should
be done before white balance alignment.
If it’s off, the way to switch it on is to reset
user/shop or set on the features in
Feature sub-item manually.
Picture related Flesh tone
Select On/Off to open/close the function
Adaptive luma
control
Select On/Off to open/close the function
Light sensor
Select On/Off to open/close the function
Dynamic
backlight
Select Auto/High/Mid/Low to set the
backlight control
White
Balance
Back light
0~100 Set the backlight
5)
Reset Shop
Item Sub-item Value Note
Reset
Shop
Clear date of NVM in user menu,include
the value related installation,and Clear
date of factory menu except the item of
Balance and sound ,set to default value
To Next Page
Loading...
Need help?
General
