12
Before reversing the door, please prepare the following tools: cross screw driver, wrench. Note:
please remove the main plug before reversing the door. Two people may be needed. Please
prepare the following items in advance:
Left upper hinge × 1 left upper hinge cover × 1 lower left hinge assembly × 1 left door stop × 2
Screw cover × 1
1.Close the door and take out the screws from the upper hinge cover with a cross screwdriver.
Remove the hinge cover, then disassemble the connection terminal, remove the top hinge and
take off upper door. Remove left screw cover.
2.Take out the screws of the middle hinge with a cross screwdriver, remove the middle hinge,
remove the screw cover at the left screw hole, and take down the lower door.
3.Laying down the refrigerator, and remove the lower hinge and leveling angle at the bottom of
the refrigerator.
4.Remove the wire cover on the upper end of the upper door, change the wiring harness from the
right side to the left side, and install the left door stop to the left side of the upper door and lower
door. (the replacement of upper door and lower door stop is the same as that of lower door, and
the lower left figure will be changed to right picture)
Operation notes
EN
To Next Page
Loading...
Need help?
General
