Operation
20
Using the external sound control
The external sound control function switches between noise cancelling, ambient sound and off. The sound
quality is set so that it is optimized for each mode.
1 While wearing the earphones, touch and hold the touch sensor (R) for about 2 seconds.
• The mode is switched each time you touch and hold the touch sensor. (A guidance message will notify you of the
mode you switched to.)
• The default level setting is “Noise cancelling”.
2 Adjust the volume of the playback device.
∫ Noise cancelling
Reduces the sounds (noise) you can hear from outside.
• While using the noise cancelling function, a very small amount of noise which is generated from the circuit that
reduces noise may be heard, but this is normal and not indicative of any trouble. (This very-low-level noise may be
heard in quiet places or in the blank parts between tracks.)
∫ Ambient sound
You can hear ambient sound through the microphones embedded in the earphones while enjoying music.
Noise cancelling Ambient sound
OFF
To Next Page
Need help?
General
Weight and Dimensions
