Technics SA-GX505 User Manual

Parametric EQ system ON/OFF button
(P. EQ SYS)
This button is used to turn the parametric EQ system ON or
OFF.
Fine mode select button (FINE)
This button is used to fine-adjust the center frequency of the
parametric EQ.
Slope changeover button [SLOPE (Q)]
This button is used to increase or decrease the slope of the
parametric EQ curves.
Parametric EQ/tone mode select button
(P.EQITONE)
This button is used to select parametric EQ mode or tone
mode.
Center frequency select/bass control
(CENTER FREQ/BASS)
This control is used to select the center frequency in the
parametric EQ mode or to adjust the low-frequency sounds
in the tone mode.
Frequency fevel/treble control
(LEVEL/TREBLE)
This control is used to adjust the frequency level in the
parametric EQ mode or the high-frequency sounds in the
tone mode.
24
@
@
Dolby Pro-Logic Surround ON/OFF button
(SURROUND)
This button is used to activate the Dolby Pro-Logic Surround
effect.
Dolby 3 stereo ON/OFF button (3 STEREO)
This button is used to activate the Dolby 3 stereo effect.
Center mode select button (CENTER MODE)
Each time you press this button, the center mode will change
as follows: NORMAL— PHANTOM— CENTER OFF.
Test signal button (TEST)
When using the center speaker and/or the rear speakers,
press this button to activate the test signal. Then adjust the
volume balance of the center speaker and/or rear speakers.
Center
speaker
level
adjustment
buttons
(CENTER
LEVEL)
“These
buttons
are
used
to
adjust
the
volume
level
of
the
center speaker.
Rear speaker level adjustment buttons
(REAR LEVEL)
These buttons are used to adjust the volume level of the rear
speakers.

Technics SA-GX505 Specifications

General

Brand	Technics
Model	SA-GX505
Category	Stereo Receiver
Language	English