35
RQT6894
Recording operations
C
1
2
3
A
A
B
COUNTER
RESET
1
COUNTER
DISPLAY
COUNTER
RESET
DISPLAY
DECK 1/2
6
3
4
2
5
132
<
OPEN
DOLBY NR
REV MODE
2
NR
ë
2
NR
ë
ªA
To display the tape counter while recording
Press [COUNTER, DISPLAY].
The counter is displayed for about 5 seconds.
≥Press [COUNTER, RESET] to reset the counter.
≥To display or reset the tape counter for deck 1, first press [DECK 1/2].
ªB
Erasing recordings
1 Press [INPUT SELECTOR] to select “TAPE”.
2 Insert the recorded tape into deck 2.
3 Press [DOLBY NR] so the “Î NR” indicator goes out.
4 Select the reverse mode.
5 Press [¥ REC PAUSE].
6 Press ["] or [!].
Erasure prevention
The illustration shows how to remove the tabs to prevent recording.
To record on the tape again, cover as shown, being careful not to cover the
high position discrimination hole.
Before recording (Deck 2 only)
See page 3 for tape selection.
Volume, sound quality and surround effects have no effect on re-
cording. Sound quality and surround effects are automatically set to
flat when recording.
Your attention is drawn to the fact that recording pre-recorded tapes
or discs or other published or broadcast material may infringe copy-
right laws.
ª
C
Preparatory steps
Do these steps before each recording.
Wind up the leader tape so recording can begin immediately.
1 Press [< OPEN] on deck 2 and insert the
cassette with tape facing down.
Close the holder by hand.
2 Press [DOLBY NR] to select Dolby NR on
(“ÎNR” appears on the tuner/amplifier) or off.
(➡ “Dolby noise reduction”, page 29)
3 Press [REV MODE] to select the reverse mode.
Each time you press the button:
b: One side only records.
d and f: Both sides record (forward>reverse).
“f” automatically changes to “d” when [¥ REC PAUSE],
[CD EDIT] or [TAPE EDIT] is pressed.
Side A
Tab for side A
Discrimination hole
Normal tape High-position tape
Forward side
Tab for side B
A
A
To Next Page
Loading...
Need help?
General
