7
English
Control reference guide
∫ Front
1 Unit on/off button [ ]
Use this button to turn the unit on and off.
[ ] (off): The unit is off.
[ ] (on): The unit is on.
≥ The unit is still using a small amount of power in off mode. Off
mode uses less power. (> 15)
2 Power indicator
The colour of the indicator changes according to the
status of this unit.
3 Peak power meter
Display the output level.
4 LAPC indicator (> 13)
5 [DIMMER]
Adjust the brightness of the light and the indicators.
Each press of this button switches the brightness.
6 [LAPC] (> 13)
Measure the characteristics of the amplifier and correct
its output.
≥ The function does not work when the speaker selector knob is
set to [OFF].
7 Input selector knob (> 13)
Select the input source or gain value.
8 Speaker selector knob (> 13)
Select the output speakers.
∫ Rear
9 Speaker terminals [SPEAKERS] (> 8)
:
Analogue audio input terminal [UNBALANCED] (
>
11)
; Analogue audio input terminal [BALANCED] (> 11)
< Analogue audio input selector switch (> 11)
Switch the analogue audio input.
≥ This switch does not work when the input selector knob is set
to [DIGITAL].
= System terminal [Technics Digital Link IN] (> 10)
> Auto off switch [AUTO OFF]
Turn on/off auto off function.
≥ Auto off function:
This unit is designed to conserve its power consumption and
save energy. The unit will turn to standby mode automatically
if there is no sound and it is not being used for approximately
20 minutes.
– To cancel this function, set to [OFF].
? Product identification marking
The model number is indicated.
@ AC IN terminal [AC IN T] (> 12)
This unit
Blue The unit is on.
Red
The unit is in standby mode.
≥ To turn on this unit from standby mode,
press the unit on/off button on this unit to
the [ ] position, and press it again
to the [ ] position.
(7)
SE-R1-SQT0461_EBEG_mst.book 7 ページ ２０１５年１月２３日 金曜日 午後４時４０分
To Next Page
Loading...
Need help?
General
