Technics SL-DL1 Operating Instructions

Specifications
@ General
Power supply:
Power consumption:
Dimensions:
(WXHX<D)
Weight:
Turntable section
Type:
Drive method:
Motor:
Turntable plaiter:
Turntable speeds:
Pitch control:
Wow and flutter:
~110-120/220-240V, 50/60Hz
17 W
43.0 X 8.8 X 35:0cm
43.0 X 39.7 < 35.0 cm
(Maximum height when top is open
all the way.)
7.1 kg (15.7 lo.)
Direct drive
Automatic turntable
Auto start/Auto lead-in
Auto return
Auto stop
Repeat play
Auto speed select
Manual speed selection possible.
Auto size select
2-speed search functions
Record presence detection
Direct drive |
Brushless DC motor
Aluminum die-cast
Diameter 31.2 cm
(12-9/32")
33-1/3 rpm and 45 rom
Auto speed select
(Manual selection possible)
10% adjustment range
0.012% WRMS*
0.025% WRMS (JIS C5521)
+0.035% peak
(i1EC 98A Weighted}
“Measured by obtaining signal from built-in frequency
generator of motor assembly.
Rumble:
—56 dB (IEC 98A Unweighted}
—78 dB (IEC 98A Weighted)
@ Tonearm section
Type:
Effective length:
Tracking error angle:
Eftective mass:
Resonance frequency:
Tonearm drive motor:
Cartridge section
Type:
Magnet:
Magnetic circuit:
Frequency response:
Output voltage:
Channel separation:
Channel balance:
Recommended load
impedance:
Compliance (dynamic):
Stylus pressure range:
Weight:
Replacement stylus:
Dynamic balanced type
Linear tracking tonearm
4-pivot gimbal suspension
10.5 cm (4-1/8"}
Within +0,1°
9 g (including cartridge)
12 Hz
DC motor
Moving magnet stereo cartridge
One point suspension system
Samarium cobalt (Sm-Co)
All laminated core
10 Hz to 35 kHz
20 Hz to 10 kHz +1 dB
2.5 mV at 1 kHz,
5 cm/s. zero to peak tateral
velocity
(7 mV at 1 KHz, 10 cm/s. zero to
peak 45° velocity [DIN 45 500})
More than 22 dB at 1 kHz
Within 1.8 dB at 1 kHz
47 kQ~100 kO
12 X 10 ©cm/dyne at 100 Hz
1.25 +0.25 g (12.5 +2.5mN)
6.0 g (cartridge only)
EPS-23CS
(Equivalent replacement stylus
EPS-23ES)
Specifications subject to change without notice.
Weight and dimensions shown are approximate.
Plug-in connector cartridges are now available from
ortofon (Denmark), Shure (U.S.A.}, Audio Technica
(Japan) as well as from Technics. All of these cartridges
are designed for perfect matching with this turntable in
all areas including weight, tracking force, stylus tip
position, and center of gravity. Therefore, you have the
option of employing a wide range of cartridges from the
world's top manufacturers without the trouble of jead
wire connections or tracking force adjustment.

Technics SL-DL1 Specifications

General

Brand	Technics
Model	SL-DL1
Category	Turntable
Language	English