Technics SL-PD988 User Manual

i
| Troubleshooting guide
Before requesting service for this unit, check the chart below for a If you are in doubt about some of the check points, or if the
possible cause of the problem you are experiencing. Some remedies indicated in the chart do not solve the problem, refer to
simple checks or a minor adjustment on your part may eliminate the directory of authorized service centers (enclosed with this
the problem and restore proper operation. unit) to locate a convenient service center, or consult your
Technics dealer for instructions.
{In U.S.A. consult PASC Authorized Servicenters for detailed
instructions or call 1-800-211-7262 for the address of an
authorized factory servicenter.)
Probable cause(s) Suggested remedy
Changer will not play. A disc{s) or other foreign object(s) has fallen ə Open the loading drawer, and then remove the
inside the changer object.
Moisture has collected in the changer + Allow the changer to dry out for about one hour
More has colecta i Mhe etanan | preuat o oooO
The disc is upside down. * Make sure the label is facing upward.
The disc in the changer
does not play.
The disc is dirty. s Wipe the disc with a soft cloth.
The disc is scratched. * Replace the disc with a new one.
The disc is warped.
The disc is not within specified standards
Ptay stops before changing | The loading drawer is open + Press the OPEN/CLOSE button to close the loading
to the next disc. drawer
A certain music passage The disc is dirty ə Wipe the disc with a soft cloth.
can't be played correctly. The disc is scratched. ə Replace the disc with a new one.
There is nolse from the Caused by high-frequency signals from this e Use the changer further away from the tuner or TV.
tuner or disturbance on the | changer. ¢ if the tuner or TV's antenna is the indoor type, use an
TV screen. outdoor one.
When program play is Play was started without a track being e Program a track.
started, an error message programmed.
(—E) appears on the
display.
An error message (— E) The mechanism of the changer has been ¢ Turn the unit off and then back on again.
appears on the display, and | improperly adjusted. However, if the loading drawer is fully open, take out
the changer stops the compact disc(s) at the front position and then turn
operating. the unit off and then back on again.
The loading drawer stops In
the middle of opening.
Product service
Do not attempt to remove the cover(s} or repair the unit
yourself,
Refer servicing to qualified personnel only.
Product information
For product service, product information or assistance in pro-
duct operation, refer to the servicenter directory.
19

Technics SL-PD988 Specifications

General

Brand	Technics
Model	SL-PD988
Category	CD Player
Language	English