Technics SL-PG440 User Manual

Program Play
You can program up to 20 tracks in any order you desire.
(Also available from the remote control)
Before beginning, follow steps 1-3 of “Basic Op¬
erating Procedure” on page 9.
1 I n the stop mode, press PROGRAM.
If you press this button in the play mode, the track in play will
be programmed.
Illuminates
2 P ress a numeric button to specify the track
number.
•To select a track between 1 and 10:
Press the corresponding number on the keypad.
•To select a two-digit track number over 10:
Press >10 then one of the buttons from 1 to 9 to select the
“tens” digit. Then press one of the buttons from 0 to 9 to select
the “unit" digit.
For example:
To select track number 25: >10 . 2 . 5
a s> □ s> □
To select track number 30: >10 . 3 0
i—i9n 9i—i
5 3 2
For example, if you press
The last track in programmed order
I Number of Total playing time of
programmed tracks programmed tracks
PGM \
_ 3
3
ID * UD
U No.
U-Dl
1 1
4 ? 6
n inn c
If you press a wrong number by mistake, press CLEAR.
•When the 21st program has been performed, the following
display indicates that no more tracks can be added.
•If the total playing time exceeds 99 minutes 59 seconds or if
the track number 21 or higher has been specified, the display
reads as follows:
J i EG _ _ ■ _ _
/_ I L
3 P ress ► PLAY to start.
•The unit stops automatically when all the programmed tracks
have finished playing.
•Even after play is completed, the program sequence will
remain in the unit’s memory. You can play the sequence
again by pressing ► PLAY.
14

Technics SL-PG440 Specifications

General

Brand	Technics
Model	SL-PG440
Category	CD Player
Language	English