12
Connections
Speakers/AC power supply cord
(12)
• Use only the supplied AC power supply cord.
• Insert the plugs of the cables to be connected all the way in.
• Do not bend cables at sharp angles.
• This unit can measure the output signal of the amplifier and correct its output to make the
optimum adjustment of speaker output. ( 24)
• To optimize the audio output from the speakers, you can measure the amplifier output
signal and correct its output when it is connected to the speakers. ( 24)
Speaker cable (not supplied)
Speaker connection
1 Turn the knobs to
loosen them, and
insert the core wires
into the holes.
2 Tighten the knobs.
Note
• When the connections are completed, pull the
speaker cables lightly to check that they are
connected firmly.
• Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so
may damage the amplifier.
DO NOT
• Wire the polarity (+/-) of the terminals correctly.
Not doing so may adversely affect stereo
effects or cause malfunction.
• For details, refer to the operating instructions of
the speakers.
• Though the spade plug (A: 16 mm (
5
/
8
”) or less,
B: 8 mm (
5
/
16
”) or more) can be connected,
some plug may not be connected depending on
the shape of plug.
AB
To Next Page
Loading...
Need help?
General
