Technoline EVO PLUS 1.000 PF User Manual

25
07
CODE
(Operational status and
mode)
08
Alarm Code(Warming
Message)
All alarm codes are
present when abnormal
behavior(s) occur(s)
3-3 UPS setting
The UPS has setting functions. This user settings can be done under any kind of
UPS working mode. The setting will take effect under certain condition. Below table
describes how to set the UPS.
The setting function is controlled by 3 buttons (FUNC/Up▲ ,OFF/Down▼,
ON/Enter): FUNC/Up ▲+OFF/Down▼---goes into the setting page, ON/Enter ---
value adjustment; FUNC/Up ▲ & OFF/Down ▼---for choosing different pages.
After the UPS turn ON, press buttons “▲&▼” for 5 seconds and then goes into
the setting interface page.
Setting saving method: After setting the project parameters, press the down
button ▼ until you enter the last page of the setting, and then press the down button
▼ to automatically exit the current setting mode, and it will take effect after powering
off and saving in battery mode.

Technoline EVO PLUS 1.000 PF Specifications

General

Brand	Technoline
Model	EVO PLUS 1.000 PF
Category	UPS
Language	English