Technoline KT-300 User Manual

 Replace battery compartment cover. The product briefly shows all the display segment
4. Installation:
 The timer has a magnet for attaching it to metal surfaces; it also can be placed onto any flat surface by
the foldable stand (C2) on the back of the housing, Or wall mounted by the hanging hole ( C1 ) at the
back of the unit.
5. Time Setting
5.1 Time Setting
Ensure that the clock display is showing in the display.
If necessary press the “CLOCK/TIMER” (B6) Button to change the display
 Hold “CLOCK” (B6) button for 3 seconds until the time of day display flashes in the upper display panel,
and enter to time setting mode.
 Use the “HR” button（B7） “MIN” button （B8） and “SEC” button（B9）to set the current time. Keep
the button pressed to accelerate the change in value.
 Press “CLOCK” (B6) button to finish the setting process and save the set time of day.
5.2 12/24 Time Format:
 The time of day can be displayed either in 24- or 12-hour mode. Press “(12/24)” button (B8) to select
12 or 24 hours format.
 In the 12-hour mode, the morning hours are shown with AM and the afternoon hours with PM.
6. Timer
6.1 Count Up Timer
 At time display mode, press “START/STOP” (B4) button to start count up
 Press “START/STOP” (B4) button in the time display mode again, to stop the count-up timer.
 Press “CLEAR” (B5) button in stop status, the count up timer will reset to “0”.
6.2 Countdown Timer
Real time display mode → Timer display mode

Technoline KT-300 Specifications

General

Brand	Technoline
Model	KT-300
Category	Timer
Language	English