no more than 25 meters from where the Weather station will be finally positioned (see notes on
“Positioning” and “433 MHz Reception”).
7. If after 10 minutes, the DCF time has not been received, use the SET key to manually enter a time initially
The clock will automatically attempt to receive the DCF time at each full hour. When this is successful, the
received time will override the manually set time. The date is also updated with the received time. (Please
refer also to notes on “Radio controlled Time Reception” and “Manual Time Setting”).
HOW TO INSTALL AND REPLACE BATTERIES IN THE WEATHER STATION
The Weather station uses 2 x AA, IEC LR6, 1.5V batteries. When batteries will
need to be replaced, the low battery icon will appear on the LCD. To install and
replace the batteries, please follow the steps below:
1. Insert finger or other solid object in the space at the bottom center of the
battery compartment and lift up to remove the cover.
2. Insert batteries observing the correct polarity (see marking).
3. Replace compartment cover.
HOW TO INSTALL AND REPLACE BATTERIES IN THE THERMO-HYGRO OUTDOOR
TRANSMITTER
The Thermo-Hygro Outdoor Transmitter uses 2 x AAA, IEC, LR3, 1.5V batteries. To install and replace the
batteries, please follow the steps below:
1. Unscrew the screw on the back of the compartment and remove the
cover.
2. Insert the batteries, observing the correct polarity (see marking).
3. Replace the battery cover on the unit and seal by re-screwing.
32
To Next Page
Loading...
Need help?
General
