WT265 Manual
unsuccessful (The radio mast symbol disappears from the
display), the system will automatically attempt another
synchronization at the next full hour. This procedure is repeated
automatically up to 5 times.
To start manual DCF signal reception manually, press and hold
the “WAVE“ button, If no signal is received within seven minutes,
then the DCF signal search stops (the radio mast symbol
disappears) and starts again the next full hour.
Please note:
If the clock cannot receive the DCF signal (because the distance
is too great to receive a signal from the transmitter in
Mainflingen,Germany), you have the option of setting the time
manually as mentioned below. As soon as the reception of the
DCF signal is possible, then the clock is readjusted
automatically.
We recommend a minimum distance of 2.5 meters(8.2 Feet) to
all sources of interference, such as televisions or computer
monitors, Radio reception is weaker in rooms with concrete
walls and in offices. In such extreme circumstances, place the
clock close to the window.
Manual time setting:
Press and hold the “TIME” button for 2 seconds, 12/24HR start
to flash. Now use “+” and “-” buttons to switch 12/24 hour mode.
Press “TIME” to confirm your setting, the time zone starts to
flash. Use“+” and “-“ buttons to set a correct time zone. For UK
time please set time zone to -1.
Press “TIME” to confirm your setting, the hour display starts to
To Next Page
Loading...
Need help?
General
