FIRST USE
Before first use, remove the unit and all accessories carefully and paying attention
to the sharp accessories.
Clean with soap and water, bowls and all accessories. Rinse and dry thoroughly.
Clean the outside and inside of the machine cabinet with a damp cloth and wipe
dry.
USE
Unroll the power cord completely.
Check that the tension in force in the country where you are corresponds to
that indicated on the apparatus.
Connect the apparatus in a correct socket-outlet, (and connected to the
ground if the unit is Class I), to avoid any danger.
Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
Never modify the appliance in anyway.
The wash is going to mix food (fruits, vegetables etc.) If need to please peel skin
or eliminate the nucleolus, Then cut into slices with 20-25mm tubby foods.
Put small pieces of food into the blend cup, Add some water properly, and then
close the big cover and tight the cup by turning the cover clockwise.
Put the blend cup on its pedestal correctly according to the mark.
Power the line plug in the power source.
Adjust the switch to speed 1 (low speed) or speed 2 (high speed) position, the
blender begins working.
Note: It only takes 30 or 50 seconds to blend foods into small pieces.
Then adjust the switch to “0” position to blender completely stop work.
When Push the switch to “ ICE CRESHED ” position, the blender will operate
immediately. When your hand is removed, it will automatically replies to “0”
position.
This function is setting for short-time blending (a few seconds), therefore it easy to
control the blending time.
Warning: When the machine is in the state of idle operation, egg. The blade fails
to touch the foods, unplug the unit until the foods have been relaxed.
Useful tips:
To achieve the best results when pureeing solid ingredients, place small
portions into the glass jar one by one instead of placing a large quantity all at
once.
To Next Page
Loading...
Need help?
Power
