WORKING WITH ALARM
SETTING THE ALARM TIME
1. Press & hold the [ALARM] button with hour flashing in the upper right corner, then rotate
the [TUNING] knob to adjust the hour.
2. Press the [ALARM] button with minutes flashing, then rotate the [TUNING] knob to
adjust the minute.
3. Press the [ALARM] button again, then rotate the [TUNING] knob to select from 1 ~ 90
minutes to set the Auto Alarm Off Timer.
4. Press the [ALARM] button to confirm the setting.
5. To turn off the alarm, press the [ALARM] button repeatedly with “
” disappears.
※ If the [ALARM] button has not been pressed again within 3 seconds, the unit will
automatically confirm the alarm setting.
HOW TO SET ALARM BY RADIO
You can preset the alarm station following below steps:
1. Turn on the radio, then tune into your favorite station for alarm by
radio and adjust your desired alarm volume level.
2. Press the [MEMORY] button with “ PRESET ” flashing, then
immediately press the [ALARM] button and notice “
” shows on the
display to confirm the preset alarm station.
HOW TO TURN OFF WHEN ALARMING
Press the [POWER] button once to continuously listen to the radio; press it twice to turn it
off.
Note: If the preset alarm is activated when you are listening to the radio, it will auto switch
to the preset alarm station. The unit will auto turn off after alarming.
SNOOZE FUNCTION
When the preset alarm is activated, you can press the [DISPLAY] button to temporarily
turn off the alarm, the unit will start alarming again 5 minutes later.
HOW TO CHANGE THE DISPLAY MODE
With radio OFF: Repeat pressing the [DISPLAY] button to view Temperature or Alarm
time display.
With radio ON: Press the [DISPLAY] button to view Local time, Alarm time,
Temperature or Signal strength/ SNR showing on the upper right corner of the display.
KEY-LOCK FUNCTION
Press & hold the [ ] button with “ ” symbol appears on the display to
activate the key lock function.
To Next Page
Loading...
Need help?
General
