Tektronix CSA7404 User Manual

Measuring Waveforms
CSA7000 Series, TDS7000 Series, & TDS6000 S eries Instruments User Manual
3- 165
Table 3- 10: Cursor units
Cursors Standard units
1
Readout names
Horizontal volts, watt s
V1, V2, ∆V
Vertical seconds, bits
T1, Τ2, ∆T, F1, F2, ∆F
Waveform, Screen volts, watts, seconds, bits
V1, V2, ∆V, T1, T2, ∆T
1
If the V1 and V2 units do not match, the ∆V readout defaults to the units used by the
V1 readout.
Multipurpose knobs. You can change cursor position using the position controls
in the Cursor setup window, dragging the cursor into position using the touch
screen or mouse, or by turning the front-panel multipurpose knobs.
The multipurpose knobs also work with other controls. If a setup window item
has an adjustable value, you can adjust it with the multipurpose knob or keypad
after touching the setup control.
NOTE. To make small changes with the multipurpose knobs, push the FINE
button before turning the knob. When a FINE button is illuminated, its multipur-
pose knob makes smaller adjustments.
You must target the cursors to the source they are to measure. (See Cursors Treat
Sources Independently on page 3--163). To do so, use the procedure that follows.
Overview To set the cursor sources Related control elements and resources
Prerequisites
1. Display the waveform to be measured on screen.
The waveform may be a channel, reference, or math
waveform.
See page 3--34 for acquisition setup and page 3--71 for
trigger setup.
To Set the Cursor Sources

Tektronix CSA7404 Specifications

General

Brand	Tektronix
Model	CSA7404
Category	Measuring Instruments
Language	English