EasyManuals Logo
Home>Tektronix>Multimeter>DMM4020

Tektronix DMM4020 Installation Manual

Tektronix DMM4020
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
DMM4020, DMM4040, and DMM4050 Connectivity InstallationManual
1
Introduction to DMM Connectivity
You can connect the digital multimeter (DMM) to the USB port on your
MS-Windows personal computer (PC) through the USB-to-Serial cable that comes
standard with your DMM. The serial end of the cable attaches to the RS-232 port
on the rear panel of the DMM, and the other end plugs into a USB port on thePC.
You can connect to a PC with a serial port through the serial port on therear-panel
of the DMM.
You can connect to a PC with IEEE-488 capability through the IEEE-488 port
on the rear panel of the DMM4040 or DMM4050.
The USB port on the front panel of the DMM4040 or DMM4050 is for USB
memory devices, not for connecting to a remote PC.
USB-to-RS232 Serial Cable Installation
To use the cable, you need to install the USB-to-RS232 drivers on your PC.This
allows the USB-to-RS232 cable to communicate between the DMM and the
PC. To install the drivers, use the Documentation Browser CD, or plug in the
USB-to-RS232 adapter and use your PC Wizard to locate and install the drivers.
On the DMM4040 or DMM4050 DMM, after you install the drivers, you can
select and set up an interface port by pushing the front-panel instrument setup key,
labelled Instr Setup, then pushing the buttons under the display with the resulting
labels Select Port, Port I/F and RS-232C (highlighted when selected).
Installation Instructionsfor
the USB-IR Optical Serial
Cable
Revision: II
Version: v1.0.2176 for WinXP/2K
v1.09.06 for WinME/98
1.
PC Requirements. To use the USB-IR serial cable, your Windows PCmust
meet the following requirements:
a)
Have an available USB port on the PC, or on a USB Hub connected to thePC.
b)
Your PC must be running one of the following versions ofWindows:
-
Windows XP (Home or Professional)
-
Windows 2000
-
Windows ME
-
Windows 98 Second Edition (only the Second Edition of Windows 98 supports
USB)
If you have a later version of Windows, you can check online at:
www.tektronix.com for an updated list of compatible versions.
www.hyxyyq.com

Other manuals for Tektronix DMM4020

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix DMM4020 and is the answer not in the manual?

Tektronix DMM4020 Specifications

General IconGeneral
BrandTektronix
ModelDMM4020
CategoryMultimeter
LanguageEnglish

Related product manuals