Commands Listed in Alphabetical Order
ACQuire:STOP
After
Sets or returns whether the oscilloscope continually acquires acquisitions or
acquires a single sequence.
Group
Acquisition
Syntax
ACQuire:STOPAfter {RUNSTop|SEQuence }
ACQuire:STOPAfter?
Related Commands
ACQuire:STATE
Arguments
RUNSTop specifies that the oscilloscope will continually acquire d ata, if
ACQuire:STATE is turned on.
SEQuence specifies that the n ext acquisition will be a single-sequence acquisition.
Examples
ACQUIRE:STOPAFTER RUNSTop sets the oscilloscope to continually acquire data.
ACQUIRE:STOPAFTER? might return:ACQUIRE:STOPAFTER SEQUENCE
indicating that the next acquisition the oscilloscope makes will be of the
single-sequence type.
ALIas
Sets or returns the state of alias functionality. Use Alias commands to define new
commands as a sequence of standard commands. You may find this useful when
repeatedly using the same commands to perform certain tasks like setting up
measurements. Aliases are similar to macros but do not include the capability to
substitute parameters into alias bodies.
To use Alias commands, first define the alias, then turn on the alias state.
Group
Alias
Syntax
ALIas { OFF|ON|<NR1>}
ALIas?
Related Commands
ALIas:DEFine
ALIas[:STATE]
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-63
To Next Page
Loading...
Need help?
General
