Getting Started
To view or chang
e the Ethernet settings on your oscilloscope, do the following:
1. On the front panel, push Utility.
2. Push Utility Page.
3. Select I/O with the Multipurpose knob.
4. Push Ethernet Network Settings.
5. If you are on a DHCP Ethernet network and using a through cable, on the
side menu set DHCP/BOOTP to On.
6. If you are using a cross-over cable, set DHCP/BOOTP to Off,andseta
hard-coded TCPIP a ddress.
Connecting via USB
You can co
nnect your oscilloscope directly to a PC by using a high-speed USB
cable, and then use software to remote ly control the oscilloscope via the PC.
Simply plug one end of the cable into the USB 2.0 high-speed device port on
the rear panel of your oscilloscope, and the other end into a USB port on your
computer.
This port requires that the cable connected from the port to the host computer
meets t he USB 2.0 specification for high speed connections. Typically, such
cables should be 3 feet or shorter in length, but this is determined by the quality of
the c
able and, with higher quality cables, this length can be extended. (It is also
dependent upon the drive c apability of the host USB port to w hich the instrument
is connected.) The use of h igh quality short cables is recommended to avoid USB
connection problems.
Once the USB cable is connected, the system automatically configures itself. To
verify that the USB is enabled:
1. On the front panel, push Utility.
2. Push Utility Page.
3
.
S
elect I/O with the Multipurpose knob.
4. Push USB, and verify that USB is enabled.
5. If USB is not enabled, push Enabled on the side menu.
After connection, the host, with appropriate software, can list the oscilloscope as a
USB device with the following parameters: (See Table 1-2.)
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 1-3
To Next Page
Loading...
Need help?
General
