Tektronix DPO2024B Programmer's Manual

Getting Started
1. Install the Tek
tronix OpenChoice Desktop software package, either from the
CD that came with your instrument or from the Tektronix website. This will
automatically install the TekVISA drivers.
2. Connect the oscilloscope to your computer with the appropriate USB, Ethernet
or GPIB cable. Cycle the power on the oscilloscope.
3. Push Utility.
4. Push Utilit
y Page.
5. Turn multipurpose knob a and select I/O.
6. If you are using USB, the system sets itself up automatically for you, if USB is
enabled. Check USB on the lower menu to be sure that USB is enabled. If it is
not enabled, push USB. Then push Connect to Computer on the side menu.
7. To use Ethernet, push Ethernet Network Settings on the lower menu. Use
the s ide menu buttons to adjust your network settings, as needed. For more
information, see the e*Scope setup information below.
8. If you are using GPIB, push GPIB. Enter the GPIB address on the side menu,
using multipurpose knob a. This will set the GPIB address on an attached
TE
K-USB-488 Adapter.
9. Run the application software on your computer.
U
sing Tektronix e*Scope
Software
Your oscilloscope contains a pre-installed remote control software package by
Tektronix called e*Scope. You can use this to “talk” to a networked PC’s web
browser so that you can view and control the oscilloscope wherever it is on your
network.
First, you’ll need to acquire an optional DPO2CONN Connectivity Module,
which provides Ethernet and video out ports for your oscilloscope (search on
www.tektronix.com).
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 1-7

Tektronix DPO2024B Specifications

General

Brand	Tektronix
Model	DPO2024B
Category	Test Equipment
Language	English