Commands Listed in Alphabetical Order
Syntax
ETHERnet:DHCP
bootp {ON |OFF}
ETHERnet:DHCPbootp?
Arguments
ON enables the oscillo
scope t o search the network for a DHCP o r BOOTP server
in order to automatically assign a dynamic IP address to the oscilloscope.
NOTE. Do not use DHCP/BOOTP searching if your oscilloscope has been
assigned a static address on a n etwork. If you set this command to ON, the
DHCP/BOOTP search will delete or change your static IP address information.
OFF disables the oscilloscope to search the network for a DHCP or BOOTP server.
Examples
ETHERNET:DHCPBOOTP ON sets the oscilloscope to search for a DHCP or BOOTP
server and assign a dynamic IP address to the oscilloscope.
ETHERnet:DNS:IPADDres
s
Sets or returns the network Domain Name S erver (Dns) IP address.
Group
Ethernet
Syntax
ETHERnet:DNS:IPADDress <QString>
ETHERnet:DNS:IPADDress?
Arguments
<QString> is a standard IP address value, enclosed in quotes.
Examples
ETHERNET:DNS:IPADDRESS “128.196.13.352” sets the Dns IP address that
the oscilloscope uses to communicate with the n etwork.
ETHERnet:DOMAINname
Sets or returns the network domain name.
Group
Ethernet
Syntax
ETHERnet:DOMAINname <Qstring>
ETHERnet:DOMAINname?
2-148 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
