To Next Page

To Previous Page

Commands Listed in Alphabetical Order

For SOUrce2: Se

ts or returns the waveform to measure "to" when taking a delay

measurement or phase measurement.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:SOUrc e<x> {CH<x>|MATH|}

MEASUrement:MEAS<x>:SOUrc e<x>?

Arguments

CH<x> is an input channel waveform, where x is the channel number.

MATH is the math waveform.

REF<x> is a reference waveform, where x is the reference channel number.

MEASUrement:MEAS<x>:STATE

Sets or returns whether the speciﬁed measurement slot is computed a nd displayed.

The measurement slot is speciﬁed by <x>, which ranges from 1 through 4.

For a measurement to display, you must have selected a source waveform

and deﬁned the measurement you want to take and display. You select the

measurement using the MEASUrement:MEAS<x>:SOURCE[1] command.

You deﬁne the measurement type using the MEASUrement:MEAS<x>:TYPe

command.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:STATE {OFF|ON|<NR1 >}

MEASUrement:MEAS<x>:STATE ?

Related Commands

MEASUrement:MEAS<x>:SOURCE[1], MEASUrement:MEAS<x>:TYPe

Arguments

OFF disables calculation and display of the speciﬁed measureme nt slot.

ON enables calculation and display of the speciﬁed measurement slot.

<NR1> = 0 disables calculation and display of the speciﬁed measurement slot; any

other value enables calculation and display of the speciﬁed measurement slot.

Examples

MEASUREMENT:MEAS2:STATE ON computes and d isplays the measurement

deﬁned as mea surement 2.

2-202 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix MSO2024B Programmer's Manual

Other manuals for Tektronix MSO2024B