Tektronix MSO4032 Technical Reference

Specifications
This chapter contains specifications for the DPO4000 and the MSO4000 series
oscilloscopes. All specifications are guaranteed unless noted as "typical."
Typical spec
ifications are provided for your convenience but are not guaranteed.
Specifications that are marked with the
symbol are checked in Performance
Verification.
All specifications apply to all DPO4000 and MSO4000 models unless noted
otherwise. To meet specifications, two conditions must first be met:
The oscilloscope must have been operating continuously for twenty minutes
within the operating temperature range specified.
You must perform the Signal Path Compensation (SPC) operation described
in the Tektronix 4000 Series Digital Phosphor Oscilloscopes User Manual
prior to evaluating specifications. If the operating temperature changes by
more than 10 °C (18 °F), you must perform the SPC operation again.
Table 1: Analog channel input and vertical specifications
Characteristic Description
DPO4032, MSO4032 DPO4104, DPO4054, DPO4034, MSO4104,
MSO4054, MSO4034
Number of input
channels
2 analog, digitized simultaneously 4 analog, digitized simultaneously
Input coupling
DC, AC, or GND
GND coupling approximates ground reference by measuring the CVR output set to GND. The signal being
measured on the BNC is not disconnected from the channel input load.
Input resistance
selection
1MΩ or 50 Ω
DPO4104, MSO4104: Bandwidth is limited to 500 MHz with 1 MΩ impedance selected.
Input impedance,
DC coupled
1MΩ ±1% in parallel with 13 pF ±2 pF
50 Ω ±1%
DPO4104, MSO4104: VSWR ≤1.5:1 from DC to 1 GHz, typical
DPO4054, MSO4054: VSWR ≤1.5:1 from DC to 500 MHz, typical
DPO4034, DPO4032, MSO4034, MSO4032: VSWR ≤1.5:1 from DC to 350 MHz, typical
Maximum input voltage
(50 Ω)
5V
RMS
with peaks ≤ ±20 V (DF ≤ 6.25%)
Maximum input voltage
(1 MΩ)
The m aximum input voltage at the BNC, between the center conductor and shield is 400 V
peak
(DF ≤
39.2%), 250 V
RMS
to 130 kHz derated to 2.6 V
RMS
at 500 MHz.
The m aximum transient withstand voltage is ±800 V
peak
DC Balance
0.2 div with the input DC 50 Ω coupled and 50 Ω terminated
0.25 div a t 2 mV/div with the input DC 50 Ω coupled and 50 Ω terminated
0.5 div at 1 mV/div with the input DC 50 Ω coupled and 50 Ω terminated
0.2 div with the input DC 1 MΩ coupled and 50 Ω terminated
0.3 div at 1 m V/div with the input DC 1 MΩ coupled and 50 Ω terminated
MSO4000 and DPO4000 Series Specifications and Performance Verification 1

Tektronix MSO4032 Specifications

General

Brand	Tektronix
Model	MSO4032
Category	Test Equipment
Language	English