Trigger Setup
If you are using the LIN bus trigger, you
can trigger on Sync, Identifier, Data, Id &
Data,Wakeup Frame, Sleep Frame,orError.
If you are using the FlexRay bus trigger, you
can trigger on Start of Frame, Type of Frame,
Identifier, Cycle Cou nt,Head er Fields, Data,
Id & Data, End of Frame or Error.
7. If you are setting up an I
2
C trigger and have
made a Trigger On selection of Address or
Address/Data, push the lower-bezel Address
buttontoaccesstheI
2
C Address side-bezel
menu.
Push th e side-bezel Addressing Mode
button and select 7bitor 10 bit.Pushthe
side-bezel Address button. Enter the address
parameters of interest with m ultipurpose knob s
a and b.
Then push the lowe r-bezel menu Direction
button and select the direction o f interest:
Read, Write,orRead or Write.
MSO4000 and DPO4000 Series Oscilloscopes User Manual 149
To Next Page
Loading...
Need help?
General
