Application E xamp les
7. Analyze t he physical layer. For example, you
can use the cursors for manual measurements.
(See page 207, Taking Manual Measurements
with Cursors.) You c an also u se the automated
measurements. (See page 190, Ta ki ng
Automatic Measureme nts .)
8. Push Search.SetSearch Marks to On. E nter
a search type, source, and other parameters
as relevant on the lower-bezel menu and
associated side-be zel menus. (See page 224,
Using Wave Inspector to Manage Long Record
Length Waveforms.)
9. Jump ahead to the next search point by
pushing the right arrow key. Push it aga in and
again until you see all the events. Jump back
withtheleftarrowkey. Doyouhaveallthe
packets that you expected to have? If not, at
least you have narrowed your search down to
the last packet sent.
308 MSO4000 and DPO4000 Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
